Hi, so this is the second hands on assignment we were assigned. This was a group project. My team mate was Calye Brown.
We tried our hands at Soldering!
Bill of material:
- SOLDERING IRON
- DAMP SPONGE
- WIRE CUTTER
- WIRE STRIPPER
- HELPING HANDS SOLDERING
- DRAWDIO KIT
- GEL PAPER
- DESOLDERING PUMP
- CIRCUIT BOARD
WE STRIPPED A WIRE ON EACH END AND SOLDERED THE WIRE TOGETHER .

I stripped the solder wire, with the wire strippers on each end. Then attached the the solder wire to the helping hands. The helping hands have claws that on each end, which grips the wire to hold it in place, while you used the solder iron.





If you take the time to notice the Blue Gel paper in the picture. The Gel paper is used to catch the material debris as they fall off.

NEXT OBJECTIVE WAS TO SOLDERING OFF THE SPEAKER AND BLACK BATTERY CASE FROM THE CIRCUIT BOARD.

The objective was to place this item in the helping hands and solder off the speaker that’s hanging off, and also solder the black component that’s meant to house battery.



Using the hot solder iron to apply heat on the top to make the black battery case to come off.
Objective 2 complete the battery case fell off. Had to use my hand to assist in pulling it down, in between the Soldering.
objective complete, soldered off the speaker and the black battery case.